Hardware

Heute

20:06 ESP32 Fehler #725 (Neu): [SN1] Enable pin pulled low

Enable->GND: 0,2 Ohm, open on unsoldered PCB
Maximilian Seesslen

07.01.2026

11:20 Helios Fehler #720: Eval-RTC: Strange behaviour when battery gets removed

Is there really a voltage feed back when battery is removed? That would be not intended. Maximilian Seesslen

11:13 Helios Fehler #722 (Neu): Resistor between BAT and "Enable" is way too high

The LED pulls it down so it will not be accepted by the MAX Chip.
There is barely a use for this resistor anyways.
Maximilian Seesslen